Your Trident Clipper engine control system detects a problem, the computer stores the diagnostic trouble
code B3382 in its memory.
To figure out what is wrong with your vehicle you must first extract the B3382 DTC For Trident Clipper.
A good ground connection is also extremely important. B3382 Trident Clipper engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
B3382 Trident Clipper DTC Meaning
Body Code - Problem is antilock brake system, electronic suspension and steering systems.
SAE - Generic
IC Module 4X Ref Circuit Intermittent, No Pulses
Crankshaft Position Sensor Circuit Performance
Kick-Down Switch Failed Short
The rule of B3382 Trident Clipper code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of B3382. Likewise, overriding the OBD B3382 DTC For Trident Clipper system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.