C0120 Subaru Outback 2 DTC Code

Subaru Outback 2 Engine Specifications:

Engine Type :	Multi-Cylinder Engine
Cylinder Type :	W-Type Engine
Engine Air Intake Process :	Turbocharged Engine

Your Subaru Outback 2 engine control system detects a problem, the computer stores the diagnostic trouble code C0120 in its memory. To figure out what is wrong with your vehicle you must first extract the C0120 DTC For Subaru Outback 2.

On 1999 and later C0120 Subaru Outback 2 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.

C0120 Subaru Outback 2 DTC Meaning

C	Chassis Code - Problem is controller area network wiring bus and modules.
0	SAE - Generic
1	Fuel And Air Metering
2	Cruise Control Servo Indicates Low
0	Transmission Engaged At High Throttle Angle

There are currently two main types of cylinder deactivation used today, depending on the type of engine. C0120 Subaru Outback 2 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.