C0140 DTC For Ford Concept

Ford Concept Engine Specifications:
Engine Type :Multi-Cylinder Engine
Cylinder Type :Opposite Piston Engine
Engine Air Intake Process :Naturally Aspirated

Your Ford Concept engine control system detects a problem, the computer stores the diagnostic trouble code C0140 in its memory. To figure out what is wrong with your vehicle you must first extract the C0140 DTC For Ford Concept.

Another consequence of C0140 Ford Concept engine overheating may be a blown head gasket. Heat makes aluminum swell almost three times faster than cast iron. Thermal stress can distort the head and make it swell in areas that are hottest like those between exhaust valves in adjoining cylinders, and areas that have restricted coolant flow like the narrow area that separates the cylinders. The typical aluminum head swells most in the middle, which can crush the head gasket if the head gets too hot. This will usually cause the head gasket to leak compression between adjacent cylinders, or leak coolant into the cylinders.

C0140 Ford Concept DTC Meaning

C Chassis Code - Problem is controller area network wiring bus and modules.
0 SAE - Generic
1 Fuel And Air Metering
4 Control Module Throttle Actuator Position Performance
0 Transmission Engaged At High Throttle Angle

If your C0140 Ford Concept check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C0140 and engine control unit are in charge of monitoring a bunch of different C0140 DTC For Ford Concept, and if they get a reading that's a little out of whack, up pops the check engine light.

C013F DTC (Previous DTC Code) ( Next DTC Code ) C0141 DTC
You can also check other Ford car models :
The listed Ford models will give information about C0140 DTC.