C0141 DTC For Alpine A610
Alpine A610 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | V-Type Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Alpine A610 engine control system detects a problem, the computer stores the diagnostic trouble
code C0141 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0141 DTC For Alpine A610.
Another consequence of C0141 Alpine A610 engine overheating may be a blown head gasket. Heat makes aluminum swell almost three times faster than cast iron. Thermal stress can distort the head and make it swell in areas that are hottest like those between exhaust valves in adjoining cylinders, and areas that have restricted coolant flow like the narrow area that separates the cylinders. The typical aluminum head swells most in the middle, which can crush the head gasket if the head gets too hot. This will usually cause the head gasket to leak compression between adjacent cylinders, or leak coolant into the cylinders.
C0141 Alpine A610 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 1 |
Fuel And Air Metering |
| 4 |
Control Module Throttle Actuator Position Performance |
| 1 |
PCM Stack Overrun |
The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. C0141 Alpine A610 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.
You can also check other Alpine car models :
|
The listed Alpine models will give information about C0141 DTC.
|
