C0533 Datsun Z DTC Code | EngineDTC.com

Datsun Z Engine Specifications:

Engine Type :	Single Cylinder Engine
Cylinder Type :	Opposite Piston Engine
Engine Air Intake Process :	Turbocharged Engine

Your Datsun Z engine control system detects a problem, the computer stores the diagnostic trouble code C0533 in its memory. To figure out what is wrong with your vehicle you must first extract the C0533 DTC For Datsun Z.

A good ground connection is also extremely important. C0533 Datsun Z engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).

C0533 Datsun Z DTC Meaning

C	Chassis Code - Problem is controller area network wiring bus and modules.
0	SAE - Generic
5	Auxiliary Emission Controls
3	Low Coolant Circuit
3	TFP Valve Position Switch-Drive Without Drive Ratio

If your vehicle failed a C0533 Datsun Z test and the C0533 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses C0533 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look C0533 DTC For Datsun Z: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.