C0942 DTC For Gobron 20
Gobron 20 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Gobron 20 engine control system detects a problem, the computer stores the diagnostic trouble
code C0942 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0942 DTC For Gobron 20.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check C0942 Gobron 20 that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
C0942 Gobron 20 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 9 |
Transmission |
| 4 |
Control Module Throttle Actuator Position Performance |
| 2 |
Kick-Down Switch Failed Short |
If your vehicle failed a C0942 Gobron 20 test and the C0942 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses C0942 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look C0942 DTC For Gobron 20: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Gobron car models :
|
The listed Gobron models will give information about C0942 DTC.
|
