C1648 DTC For Overland 40
Overland 40 Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | In-Line Engine |
Engine Air Intake Process : | Supercharged Engine |
Your Overland 40 engine control system detects a problem, the computer stores the diagnostic trouble
code C1648 in its memory.
To figure out what is wrong with your vehicle you must first extract the C1648 DTC For Overland 40.
On 1999 and later C1648 Overland 40 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
C1648 Overland 40 DTC Meaning
C |
Chassis Code - Problem is controller area network wiring bus and modules. |
1 |
MFG - Manufacturer Specific |
6 |
Vehicle Speed Control And Idle Control System |
4 |
Control Module Throttle Actuator Position Performance |
8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
The C1648 Overland 40 Check Engine lamp is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. C1648 diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks C1648 DTC For Overland 40 with your car's computers to find out exactly what's prompting the light to turn on.
You can also check other Overland car models :
The listed Overland models will give information about C1648 DTC.
|