C3391 DTC For Honda Step

Honda Step Engine Specifications:
Engine Type :Single Cylinder Engine
Cylinder Type :Opposite Piston Engine
Engine Air Intake Process :Naturally Aspirated

Your Honda Step engine control system detects a problem, the computer stores the diagnostic trouble code C3391 in its memory. To figure out what is wrong with your vehicle you must first extract the C3391 DTC For Honda Step.

Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check C3391 Honda Step that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.

C3391 Honda Step DTC Meaning

C Chassis Code - Problem is controller area network wiring bus and modules.
3 SAE - Generic
3 IC Module 4X Ref Circuit Intermittent, No Pulses
9 TP Sensor Learn Not Complete
1 PCM Stack Overrun

If your vehicle failed a C3391 Honda Step test and the C3391 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses C3391 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look C3391 DTC For Honda Step: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.

C3390 DTC (Previous DTC Code) ( Next DTC Code ) C3392 DTC
You can also check other Honda car models :
The listed Honda models will give information about C3391 DTC.