P1710 DTC For Mercedes E 500
Mercedes E 500 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Mercedes E 500 engine control system detects a problem, the computer stores the diagnostic trouble
code P1710 in its memory.
To figure out what is wrong with your vehicle you must first extract the P1710 DTC For Mercedes E 500.
P1710 Mercedes E 500 engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
P1710 Mercedes E 500 DTC Meaning
| P |
Powertrain Code - Problem is related engine, transmission and emissions systems. |
| 1 |
MFG - Manufacturer Specific |
| 7 |
Ignition System Or Misfire |
| 1 |
IC Circuit High Voltage |
| 0 |
Transmission Engaged At High Throttle Angle |
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the P1710 Mercedes E 500 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
You can also check other Mercedes car models :
|
The listed Mercedes models will give information about P1710 DTC.
|
