P1E42 DTC For Thames 50
Thames 50 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Thames 50 engine control system detects a problem, the computer stores the diagnostic trouble
code P1E42 in its memory.
To figure out what is wrong with your vehicle you must first extract the P1E42 DTC For Thames 50.
To solve P1E42 Thames 50 problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
P1E42 Thames 50 DTC Meaning
| P |
Powertrain Code - Problem is related engine, transmission and emissions systems. |
| 1 |
MFG - Manufacturer Specific |
| E |
Transmission |
| 4 |
Control Module Throttle Actuator Position Performance |
| 2 |
Kick-Down Switch Failed Short |
If your vehicle failed a P1E42 Thames 50 test and the P1E42 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses P1E42 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look P1E42 DTC For Thames 50: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Thames car models :
|
The listed Thames models will give information about P1E42 DTC.
|
