Your Honda Stepwagon engine control system detects a problem, the computer stores the diagnostic trouble
code P205D in its memory.
To figure out what is wrong with your vehicle you must first extract the P205D DTC For Honda Stepwagon.
Another consequence of P205D Honda Stepwagon engine overheating may be a blown head gasket. Heat makes aluminum swell almost three times faster than cast iron. Thermal stress can distort the head and make it swell in areas that are hottest like those between exhaust valves in adjoining cylinders, and areas that have restricted coolant flow like the narrow area that separates the cylinders. The typical aluminum head swells most in the middle, which can crush the head gasket if the head gets too hot. This will usually cause the head gasket to leak compression between adjacent cylinders, or leak coolant into the cylinders.
P205D Honda Stepwagon DTC Meaning
Powertrain Code - Problem is related engine, transmission and emissions systems.
MFG - Manufacturer Specific
BBV Sensor Circuit Low Voltage
TFP Valve Position Switch-Drive Without Drive Ratio
When you turn on the ignition, the Service Engine Soon or Check Engine P205D Honda Stepwagon light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If P205D DTC For Honda Stepwagon so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the P205D!