U006A DTC For Ginetta G33
Ginetta G33 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | V-Type Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Ginetta G33 engine control system detects a problem, the computer stores the diagnostic trouble
code U006A in its memory.
To figure out what is wrong with your vehicle you must first extract the U006A DTC For Ginetta G33.
U006A Ginetta G33 engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
U006A Ginetta G33 DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 0 |
SAE - Generic |
| 0 |
Transmission |
| 6 |
Vehicle Speed Output Circuit |
| A |
TFP Valve Position Switch-Drive Without Drive Ratio |
The rule of U006A Ginetta G33 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of U006A. Likewise, overriding the OBD U006A DTC For Ginetta G33 system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
You can also check other Ginetta car models :
|
The listed Ginetta models will give information about U006A DTC.
|
