U0341 DTC For Ford M350
Ford M350 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Ford M350 engine control system detects a problem, the computer stores the diagnostic trouble
code U0341 in its memory.
To figure out what is wrong with your vehicle you must first extract the U0341 DTC For Ford M350.
On 1999 and later U0341 Ford M350 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
U0341 Ford M350 DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 0 |
SAE - Generic |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 4 |
Control Module Throttle Actuator Position Performance |
| 1 |
PCM Stack Overrun |
When you turn on the ignition, the Service Engine Soon or Check Engine U0341 Ford M350 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If U0341 DTC For Ford M350 so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the U0341!
You can also check other Ford car models :
|
The listed Ford models will give information about U0341 DTC.
|
