U20F4 DTC For Isuzu I 290
Isuzu I 290 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Isuzu I 290 engine control system detects a problem, the computer stores the diagnostic trouble
code U20F4 in its memory.
To figure out what is wrong with your vehicle you must first extract the U20F4 DTC For Isuzu I 290.
On 1999 and later U20F4 Isuzu I 290 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
U20F4 Isuzu I 290 DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 2 |
MFG - Manufacturer Specific |
| 0 |
Transmission |
| F |
BBV Sensor Circuit Low Voltage |
| 4 |
Cruise Vehicle Speed/Set Speed Difference Too High |
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the U20F4 Isuzu I 290 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
You can also check other Isuzu car models :
|
The listed Isuzu models will give information about U20F4 DTC.
|
