B1148 DTC For Toyota Allion
Toyota Allion Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Toyota Allion engine control system detects a problem, the computer stores the diagnostic trouble
code B1148 in its memory.
To figure out what is wrong with your vehicle you must first extract the B1148 DTC For Toyota Allion.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check B1148 Toyota Allion that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
B1148 Toyota Allion DTC Meaning
| B |
Body Code - Problem is antilock brake system, electronic suspension and steering systems. |
| 1 |
MFG - Manufacturer Specific |
| 1 |
Fuel And Air Metering |
| 4 |
Control Module Throttle Actuator Position Performance |
| 8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
If your vehicle failed a B1148 Toyota Allion test and the B1148 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses B1148 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look B1148 DTC For Toyota Allion: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Toyota car models :
|
The listed Toyota models will give information about B1148 DTC.
|
