B2943 DTC For Mazda Az

Mazda Az Engine Specifications:
Engine Type :Single Cylinder Engine
Cylinder Type :Opposite Piston Engine
Engine Air Intake Process :Naturally Aspirated

Your Mazda Az engine control system detects a problem, the computer stores the diagnostic trouble code B2943 in its memory. To figure out what is wrong with your vehicle you must first extract the B2943 DTC For Mazda Az.

To solve B2943 Mazda Az problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs

B2943 Mazda Az DTC Meaning

B Body Code - Problem is antilock brake system, electronic suspension and steering systems.
2 MFG - Manufacturer Specific
9 Transmission
4 Control Module Throttle Actuator Position Performance
3 TFP Valve Position Switch-Drive Without Drive Ratio

If your vehicle failed a B2943 Mazda Az test and the B2943 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses B2943 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look B2943 DTC For Mazda Az: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.

B2942 DTC (Previous DTC Code) ( Next DTC Code ) B2944 DTC
You can also check other Mazda car models :
The listed Mazda models will give information about B2943 DTC.