B3146 DTC For Toyota Conquest
Toyota Conquest Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | Opposite Piston Engine |
Engine Air Intake Process : | Naturally Aspirated |
Your Toyota Conquest engine control system detects a problem, the computer stores the diagnostic trouble
code B3146 in its memory.
To figure out what is wrong with your vehicle you must first extract the B3146 DTC For Toyota Conquest.
To solve B3146 Toyota Conquest problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
B3146 Toyota Conquest DTC Meaning
B |
Body Code - Problem is antilock brake system, electronic suspension and steering systems. |
3 |
SAE - Generic |
1 |
Fuel And Air Metering |
4 |
Control Module Throttle Actuator Position Performance |
6 |
Transmission Control Module Reprogrammable Memory |
If your vehicle failed a B3146 Toyota Conquest test and the B3146 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses B3146 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look B3146 DTC For Toyota Conquest: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Toyota car models :
The listed Toyota models will give information about B3146 DTC.
|