C010C Subaru Svx DTC Code

Subaru Svx Engine Specifications:

Engine Type :	Single Cylinder Engine
Cylinder Type :	Opposite Piston Engine
Engine Air Intake Process :	Naturally Aspirated

Your Subaru Svx engine control system detects a problem, the computer stores the diagnostic trouble code C010C in its memory. To figure out what is wrong with your vehicle you must first extract the C010C DTC For Subaru Svx.

To solve C010C Subaru Svx problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs

C010C Subaru Svx DTC Meaning

C	Chassis Code - Problem is controller area network wiring bus and modules.
0	SAE - Generic
1	Fuel And Air Metering
0	Air Conditioning (A/C) Clutch Feedback Circuit High Voltage
C	TFP Valve Position Switch-Drive Without Drive Ratio

If your vehicle failed a C010C Subaru Svx test and the C010C Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses C010C a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look C010C DTC For Subaru Svx: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.