C0112 DTC For Alpine Cabriolet
Alpine Cabriolet Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | W-Type Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Alpine Cabriolet engine control system detects a problem, the computer stores the diagnostic trouble
code C0112 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0112 DTC For Alpine Cabriolet.
A good ground connection is also extremely important. C0112 Alpine Cabriolet engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C0112 Alpine Cabriolet DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 1 |
Fuel And Air Metering |
| 1 |
IC Circuit High Voltage |
| 2 |
Kick-Down Switch Failed Short |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C0112 Alpine Cabriolet code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Alpine car models :
|
The listed Alpine models will give information about C0112 DTC.
|
