C0118 DTC For Subaru Legacy 4

Subaru Legacy 4 Engine Specifications:
Engine Type :Single Cylinder Engine
Cylinder Type :W-Type Engine
Engine Air Intake Process :Turbocharged Engine

Your Subaru Legacy 4 engine control system detects a problem, the computer stores the diagnostic trouble code C0118 in its memory. To figure out what is wrong with your vehicle you must first extract the C0118 DTC For Subaru Legacy 4.

On 1999 and later C0118 Subaru Legacy 4 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.

C0118 Subaru Legacy 4 DTC Meaning

C Chassis Code - Problem is controller area network wiring bus and modules.
0 SAE - Generic
1 Fuel And Air Metering
1 IC Circuit High Voltage
8 Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit

The scent may C0118 Subaru Legacy 4 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such C0118, so if the inside of your car C0118 DTC For Subaru Legacy 4 as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

C0117 DTC (Previous DTC Code) ( Next DTC Code ) C0119 DTC
You can also check other Subaru car models :
The listed Subaru models will give information about C0118 DTC.