C0125 DTC For Subaru Forester 1
Subaru Forester 1 Engine Specifications:
Engine Type : | Multi-Cylinder Engine |
Cylinder Type : | V-Type Engine |
Engine Air Intake Process : | Turbocharged Engine |
Your Subaru Forester 1 engine control system detects a problem, the computer stores the diagnostic trouble
code C0125 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0125 DTC For Subaru Forester 1.
A good ground connection is also extremely important. C0125 Subaru Forester 1 engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C0125 Subaru Forester 1 DTC Meaning
C |
Chassis Code - Problem is controller area network wiring bus and modules. |
0 |
SAE - Generic |
1 |
Fuel And Air Metering |
2 |
Cruise Control Servo Indicates Low |
5 |
Cruise Inhibit Control Circuit |
The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. C0125 Subaru Forester 1 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.
You can also check other Subaru car models :
The listed Subaru models will give information about C0125 DTC.
|