C0131 DTC For Subaru H6
Subaru H6 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Subaru H6 engine control system detects a problem, the computer stores the diagnostic trouble
code C0131 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0131 DTC For Subaru H6.
On 1999 and later C0131 Subaru H6 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
C0131 Subaru H6 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 1 |
Fuel And Air Metering |
| 3 |
Low Coolant Circuit |
| 1 |
PCM Stack Overrun |
When you turn on the ignition, the Service Engine Soon or Check Engine C0131 Subaru H6 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If C0131 DTC For Subaru H6 so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the C0131!
You can also check other Subaru car models :
|
The listed Subaru models will give information about C0131 DTC.
|
