C0138 DTC For Alpine V6
Alpine V6 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | V-Type Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Alpine V6 engine control system detects a problem, the computer stores the diagnostic trouble
code C0138 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0138 DTC For Alpine V6.
On 1999 and later C0138 Alpine V6 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
C0138 Alpine V6 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 1 |
Fuel And Air Metering |
| 3 |
Low Coolant Circuit |
| 8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
The rule of C0138 Alpine V6 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of C0138. Likewise, overriding the OBD C0138 DTC For Alpine V6 system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
You can also check other Alpine car models :
|
The listed Alpine models will give information about C0138 DTC.
|
