C013F DTC For Alpine A108 904
Alpine A108 904 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | W-Type Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Alpine A108 904 engine control system detects a problem, the computer stores the diagnostic trouble
code C013F in its memory.
To figure out what is wrong with your vehicle you must first extract the C013F DTC For Alpine A108 904.
On 1999 and later C013F Alpine A108 904 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
C013F Alpine A108 904 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 1 |
Fuel And Air Metering |
| 3 |
Low Coolant Circuit |
| F |
TFP Valve Position Switch-Drive Without Drive Ratio |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C013F Alpine A108 904 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Alpine car models :
|
The listed Alpine models will give information about C013F DTC.
|
