C0142 DTC For Alpine V6
Alpine V6 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Alpine V6 engine control system detects a problem, the computer stores the diagnostic trouble
code C0142 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0142 DTC For Alpine V6.
To solve C0142 Alpine V6 problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
C0142 Alpine V6 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 1 |
Fuel And Air Metering |
| 4 |
Control Module Throttle Actuator Position Performance |
| 2 |
Kick-Down Switch Failed Short |
If your vehicle failed a C0142 Alpine V6 test and the C0142 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses C0142 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look C0142 DTC For Alpine V6: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Alpine car models :
|
The listed Alpine models will give information about C0142 DTC.
|
