C0145 DTC For Alpine Coupe
Alpine Coupe Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | V-Type Engine |
Engine Air Intake Process : | Turbocharged Engine |
Your Alpine Coupe engine control system detects a problem, the computer stores the diagnostic trouble
code C0145 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0145 DTC For Alpine Coupe.
C0145 Alpine Coupe engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
C0145 Alpine Coupe DTC Meaning
C |
Chassis Code - Problem is controller area network wiring bus and modules. |
0 |
SAE - Generic |
1 |
Fuel And Air Metering |
4 |
Control Module Throttle Actuator Position Performance |
5 |
Cruise Inhibit Control Circuit |
The rule of C0145 Alpine Coupe code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of C0145. Likewise, overriding the OBD C0145 DTC For Alpine Coupe system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
You can also check other Alpine car models :
The listed Alpine models will give information about C0145 DTC.
|