C0148 DTC For Alpine A108 904
Alpine A108 904 Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | W-Type Engine |
Engine Air Intake Process : | Turbocharged Engine |
Your Alpine A108 904 engine control system detects a problem, the computer stores the diagnostic trouble
code C0148 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0148 DTC For Alpine A108 904.
A good ground connection is also extremely important. C0148 Alpine A108 904 engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C0148 Alpine A108 904 DTC Meaning
C |
Chassis Code - Problem is controller area network wiring bus and modules. |
0 |
SAE - Generic |
1 |
Fuel And Air Metering |
4 |
Control Module Throttle Actuator Position Performance |
8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
The scent may C0148 Alpine A108 904 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such C0148, so if the inside of your car C0148 DTC For Alpine A108 904 as if you were standing behind your car, get out and get it fixed. Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.
You can also check other Alpine car models :
The listed Alpine models will give information about C0148 DTC.
|