C0528 DTC For Datsun 100
Datsun 100 Engine Specifications:
Engine Type : | Multi-Cylinder Engine |
Cylinder Type : | W-Type Engine |
Engine Air Intake Process : | Turbocharged Engine |
Your Datsun 100 engine control system detects a problem, the computer stores the diagnostic trouble
code C0528 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0528 DTC For Datsun 100.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check C0528 Datsun 100 that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
C0528 Datsun 100 DTC Meaning
C |
Chassis Code - Problem is controller area network wiring bus and modules. |
0 |
SAE - Generic |
5 |
Auxiliary Emission Controls |
2 |
Cruise Control Servo Indicates Low |
8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C0528 Datsun 100 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Datsun car models :
The listed Datsun models will give information about C0528 DTC.
|