C0538 DTC For Datsun 100
Datsun 100 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | W-Type Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Datsun 100 engine control system detects a problem, the computer stores the diagnostic trouble
code C0538 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0538 DTC For Datsun 100.
A good ground connection is also extremely important. C0538 Datsun 100 engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C0538 Datsun 100 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 5 |
Auxiliary Emission Controls |
| 3 |
Low Coolant Circuit |
| 8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C0538 Datsun 100 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Datsun car models :
|
The listed Datsun models will give information about C0538 DTC.
|
