C0548 DTC For Datsun On Do
Datsun On Do Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Datsun On Do engine control system detects a problem, the computer stores the diagnostic trouble
code C0548 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0548 DTC For Datsun On Do.
On 1999 and later C0548 Datsun On Do engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
C0548 Datsun On Do DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 5 |
Auxiliary Emission Controls |
| 4 |
Control Module Throttle Actuator Position Performance |
| 8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
When you turn on the ignition, the Service Engine Soon or Check Engine C0548 Datsun On Do light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If C0548 DTC For Datsun On Do so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the C0548!
You can also check other Datsun car models :
|
The listed Datsun models will give information about C0548 DTC.
|
