C0995 DTC For Fiat 3
Fiat 3 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Fiat 3 engine control system detects a problem, the computer stores the diagnostic trouble
code C0995 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0995 DTC For Fiat 3.
On 1999 and later C0995 Fiat 3 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
C0995 Fiat 3 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 9 |
Transmission |
| 9 |
TP Sensor Learn Not Complete |
| 5 |
Cruise Inhibit Control Circuit |
If your vehicle failed a C0995 Fiat 3 test and the C0995 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses C0995 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look C0995 DTC For Fiat 3: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Fiat car models :
|
The listed Fiat models will give information about C0995 DTC.
|
