C12FE DTC For Toyota Kluger
Toyota Kluger Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Toyota Kluger engine control system detects a problem, the computer stores the diagnostic trouble
code C12FE in its memory.
To figure out what is wrong with your vehicle you must first extract the C12FE DTC For Toyota Kluger.
To solve C12FE Toyota Kluger problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
C12FE Toyota Kluger DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 1 |
MFG - Manufacturer Specific |
| 2 |
Computer And Auxiliary Outputs |
| F |
BBV Sensor Circuit Low Voltage |
| E |
TFP Valve Position Switch-Drive Without Drive Ratio |
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C12FE Toyota Kluger code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
You can also check other Toyota car models :
|
The listed Toyota models will give information about C12FE DTC.
|
