C1312 DTC For Toyota Chaser
Toyota Chaser Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Toyota Chaser engine control system detects a problem, the computer stores the diagnostic trouble
code C1312 in its memory.
To figure out what is wrong with your vehicle you must first extract the C1312 DTC For Toyota Chaser.
A good ground connection is also extremely important. C1312 Toyota Chaser engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C1312 Toyota Chaser DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 1 |
MFG - Manufacturer Specific |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 1 |
IC Circuit High Voltage |
| 2 |
Kick-Down Switch Failed Short |
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C1312 Toyota Chaser code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
You can also check other Toyota car models :
|
The listed Toyota models will give information about C1312 DTC.
|
