C1328 DTC For Toyota Sequoia
Toyota Sequoia Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | V-Type Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Toyota Sequoia engine control system detects a problem, the computer stores the diagnostic trouble
code C1328 in its memory.
To figure out what is wrong with your vehicle you must first extract the C1328 DTC For Toyota Sequoia.
Another consequence of C1328 Toyota Sequoia engine overheating may be a blown head gasket. Heat makes aluminum swell almost three times faster than cast iron. Thermal stress can distort the head and make it swell in areas that are hottest like those between exhaust valves in adjoining cylinders, and areas that have restricted coolant flow like the narrow area that separates the cylinders. The typical aluminum head swells most in the middle, which can crush the head gasket if the head gets too hot. This will usually cause the head gasket to leak compression between adjacent cylinders, or leak coolant into the cylinders.
C1328 Toyota Sequoia DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 1 |
MFG - Manufacturer Specific |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 2 |
Cruise Control Servo Indicates Low |
| 8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. C1328 Toyota Sequoia code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.
You can also check other Toyota car models :
|
The listed Toyota models will give information about C1328 DTC.
|
