C1341 DTC For Toyota Mr2 Spyder
Toyota Mr2 Spyder Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | W-Type Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Toyota Mr2 Spyder engine control system detects a problem, the computer stores the diagnostic trouble
code C1341 in its memory.
To figure out what is wrong with your vehicle you must first extract the C1341 DTC For Toyota Mr2 Spyder.
On 1999 and later C1341 Toyota Mr2 Spyder engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
C1341 Toyota Mr2 Spyder DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 1 |
MFG - Manufacturer Specific |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 4 |
Control Module Throttle Actuator Position Performance |
| 1 |
PCM Stack Overrun |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C1341 Toyota Mr2 Spyder code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Toyota car models :
|
The listed Toyota models will give information about C1341 DTC.
|
