C1351 DTC For Toyota Mark Ii

Toyota Mark Ii Engine Specifications:
Engine Type :Single Cylinder Engine
Cylinder Type :Opposed Cylinder Engine
Engine Air Intake Process :Supercharged Engine

Your Toyota Mark Ii engine control system detects a problem, the computer stores the diagnostic trouble code C1351 in its memory. To figure out what is wrong with your vehicle you must first extract the C1351 DTC For Toyota Mark Ii.

On 1999 and later C1351 Toyota Mark Ii engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.

C1351 Toyota Mark Ii DTC Meaning

C Chassis Code - Problem is controller area network wiring bus and modules.
1 MFG - Manufacturer Specific
3 IC Module 4X Ref Circuit Intermittent, No Pulses
5 BBV Sensor Circuit Low Voltage
1 PCM Stack Overrun

While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C1351 Toyota Mark Ii code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.

C1350 DTC (Previous DTC Code) ( Next DTC Code ) C1352 DTC
You can also check other Toyota car models :
The listed Toyota models will give information about C1351 DTC.