C1357 DTC For Toyota Proace
Toyota Proace Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Toyota Proace engine control system detects a problem, the computer stores the diagnostic trouble
code C1357 in its memory.
To figure out what is wrong with your vehicle you must first extract the C1357 DTC For Toyota Proace.
Another consequence of C1357 Toyota Proace engine overheating may be a blown head gasket. Heat makes aluminum swell almost three times faster than cast iron. Thermal stress can distort the head and make it swell in areas that are hottest like those between exhaust valves in adjoining cylinders, and areas that have restricted coolant flow like the narrow area that separates the cylinders. The typical aluminum head swells most in the middle, which can crush the head gasket if the head gets too hot. This will usually cause the head gasket to leak compression between adjacent cylinders, or leak coolant into the cylinders.
C1357 Toyota Proace DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 1 |
MFG - Manufacturer Specific |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 5 |
BBV Sensor Circuit Low Voltage |
| 7 |
Cruise Control System - Vehicle Accel Too High |
When you turn on the ignition, the Service Engine Soon or Check Engine C1357 Toyota Proace light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If C1357 DTC For Toyota Proace so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the C1357!
You can also check other Toyota car models :
|
The listed Toyota models will give information about C1357 DTC.
|
