C1358 DTC For Toyota Chaser
Toyota Chaser Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Toyota Chaser engine control system detects a problem, the computer stores the diagnostic trouble
code C1358 in its memory.
To figure out what is wrong with your vehicle you must first extract the C1358 DTC For Toyota Chaser.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check C1358 Toyota Chaser that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
C1358 Toyota Chaser DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 1 |
MFG - Manufacturer Specific |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 5 |
BBV Sensor Circuit Low Voltage |
| 8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
If your vehicle failed a C1358 Toyota Chaser test and the C1358 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses C1358 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look C1358 DTC For Toyota Chaser: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Toyota car models :
|
The listed Toyota models will give information about C1358 DTC.
|
