Your Hyundai I30 engine control system detects a problem, the computer stores the diagnostic trouble
code C229C in its memory.
To figure out what is wrong with your vehicle you must first extract the C229C DTC For Hyundai I30.
A good ground connection is also extremely important. C229C Hyundai I30 engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C229C Hyundai I30 DTC Meaning
Chassis Code - Problem is controller area network wiring bus and modules.
MFG - Manufacturer Specific
Computer And Auxiliary Outputs
TP Sensor Learn Not Complete
TFP Valve Position Switch-Drive Without Drive Ratio
When you turn on the ignition, the Service Engine Soon or Check Engine C229C Hyundai I30 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If C229C DTC For Hyundai I30 so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the C229C!