Your Sunbeam Chamois engine control system detects a problem, the computer stores the diagnostic trouble
code C2542 in its memory.
To figure out what is wrong with your vehicle you must first extract the C2542 DTC For Sunbeam Chamois.
A good ground connection is also extremely important. C2542 Sunbeam Chamois engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C2542 Sunbeam Chamois DTC Meaning
Chassis Code - Problem is controller area network wiring bus and modules.
MFG - Manufacturer Specific
Auxiliary Emission Controls
Control Module Throttle Actuator Position Performance
Kick-Down Switch Failed Short
The rule of C2542 Sunbeam Chamois code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of C2542. Likewise, overriding the OBD C2542 DTC For Sunbeam Chamois system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.