C2643 Austin Healey 100 DTC Code

Austin Healey 100 Engine Specifications:

Engine Type :	Multi-Cylinder Engine
Cylinder Type :	Opposed Cylinder Engine
Engine Air Intake Process :	Naturally Aspirated

Your Austin Healey 100 engine control system detects a problem, the computer stores the diagnostic trouble code C2643 in its memory. To figure out what is wrong with your vehicle you must first extract the C2643 DTC For Austin Healey 100.

On 1999 and later C2643 Austin Healey 100 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.

C2643 Austin Healey 100 DTC Meaning

C	Chassis Code - Problem is controller area network wiring bus and modules.
2	MFG - Manufacturer Specific
6	Vehicle Speed Control And Idle Control System
4	Control Module Throttle Actuator Position Performance
3	TFP Valve Position Switch-Drive Without Drive Ratio

When you turn on the ignition, the Service Engine Soon or Check Engine C2643 Austin Healey 100 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If C2643 DTC For Austin Healey 100 so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the C2643!