C2643 DTC For Bristol Brigand
Bristol Brigand Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | W-Type Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Bristol Brigand engine control system detects a problem, the computer stores the diagnostic trouble
code C2643 in its memory.
To figure out what is wrong with your vehicle you must first extract the C2643 DTC For Bristol Brigand.
Another consequence of C2643 Bristol Brigand engine overheating may be a blown head gasket. Heat makes aluminum swell almost three times faster than cast iron. Thermal stress can distort the head and make it swell in areas that are hottest like those between exhaust valves in adjoining cylinders, and areas that have restricted coolant flow like the narrow area that separates the cylinders. The typical aluminum head swells most in the middle, which can crush the head gasket if the head gets too hot. This will usually cause the head gasket to leak compression between adjacent cylinders, or leak coolant into the cylinders.
C2643 Bristol Brigand DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 2 |
MFG - Manufacturer Specific |
| 6 |
Vehicle Speed Control And Idle Control System |
| 4 |
Control Module Throttle Actuator Position Performance |
| 3 |
TFP Valve Position Switch-Drive Without Drive Ratio |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C2643 Bristol Brigand code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Bristol car models :
|
The listed Bristol models will give information about C2643 DTC.
|
