C2643 Hyundai Santa Fe Ii DTC Code

Hyundai Santa Fe Ii Engine Specifications:

Engine Type :	Multi-Cylinder Engine
Cylinder Type :	V-Type Engine
Engine Air Intake Process :	Turbocharged Engine

Your Hyundai Santa Fe Ii engine control system detects a problem, the computer stores the diagnostic trouble code C2643 in its memory. To figure out what is wrong with your vehicle you must first extract the C2643 DTC For Hyundai Santa Fe Ii.

A good ground connection is also extremely important. C2643 Hyundai Santa Fe Ii engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).

C2643 Hyundai Santa Fe Ii DTC Meaning

C	Chassis Code - Problem is controller area network wiring bus and modules.
2	MFG - Manufacturer Specific
6	Vehicle Speed Control And Idle Control System
4	Control Module Throttle Actuator Position Performance
3	TFP Valve Position Switch-Drive Without Drive Ratio

The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. C2643 Hyundai Santa Fe Ii code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.