C2687 DTC For Ginetta G12
Ginetta G12 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | W-Type Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Ginetta G12 engine control system detects a problem, the computer stores the diagnostic trouble
code C2687 in its memory.
To figure out what is wrong with your vehicle you must first extract the C2687 DTC For Ginetta G12.
C2687 Ginetta G12 engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
C2687 Ginetta G12 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 2 |
MFG - Manufacturer Specific |
| 6 |
Vehicle Speed Control And Idle Control System |
| 8 |
Crankshaft Position Sensor Circuit Performance |
| 7 |
Cruise Control System - Vehicle Accel Too High |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C2687 Ginetta G12 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Ginetta car models :
|
The listed Ginetta models will give information about C2687 DTC.
|
