C2828 DTC For Caterham Seven S3
Caterham Seven S3 Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | Opposed Cylinder Engine |
Engine Air Intake Process : | Turbocharged Engine |
Your Caterham Seven S3 engine control system detects a problem, the computer stores the diagnostic trouble
code C2828 in its memory.
To figure out what is wrong with your vehicle you must first extract the C2828 DTC For Caterham Seven S3.
C2828 Caterham Seven S3 engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
C2828 Caterham Seven S3 DTC Meaning
C |
Chassis Code - Problem is controller area network wiring bus and modules. |
2 |
MFG - Manufacturer Specific |
8 |
Accelerator Pedal Position (APP) Sensor 1 Performance |
2 |
Cruise Control Servo Indicates Low |
8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C2828 Caterham Seven S3 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
You can also check other Caterham car models :
The listed Caterham models will give information about C2828 DTC.
|