C3248 Buick Enclave DTC Code

Buick Enclave Engine Specifications:

Engine Type :	Single Cylinder Engine
Cylinder Type :	Opposite Piston Engine
Engine Air Intake Process :	Supercharged Engine

Your Buick Enclave engine control system detects a problem, the computer stores the diagnostic trouble code C3248 in its memory. To figure out what is wrong with your vehicle you must first extract the C3248 DTC For Buick Enclave.

Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check C3248 Buick Enclave that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.

C3248 Buick Enclave DTC Meaning

C	Chassis Code - Problem is controller area network wiring bus and modules.
3	SAE - Generic
2	Computer And Auxiliary Outputs
4	Control Module Throttle Actuator Position Performance
8	Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit

If your vehicle failed a C3248 Buick Enclave test and the C3248 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses C3248 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look C3248 DTC For Buick Enclave: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.