C3373 DTC For Mercedes Cl 500
Mercedes Cl 500 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | W-Type Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Mercedes Cl 500 engine control system detects a problem, the computer stores the diagnostic trouble
code C3373 in its memory.
To figure out what is wrong with your vehicle you must first extract the C3373 DTC For Mercedes Cl 500.
On 1999 and later C3373 Mercedes Cl 500 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
C3373 Mercedes Cl 500 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 3 |
SAE - Generic |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 7 |
Exhaust Gas Recirculation System Valve 1 |
| 3 |
TFP Valve Position Switch-Drive Without Drive Ratio |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C3373 Mercedes Cl 500 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Mercedes car models :
|
The listed Mercedes models will give information about C3373 DTC.
|
