C3384 DTC For Mercedes Benz G Class

Mercedes Benz G Class Engine Specifications:
Engine Type :Single Cylinder Engine
Cylinder Type :Opposed Cylinder Engine
Engine Air Intake Process :Supercharged Engine

Your Mercedes Benz G Class engine control system detects a problem, the computer stores the diagnostic trouble code C3384 in its memory. To figure out what is wrong with your vehicle you must first extract the C3384 DTC For Mercedes Benz G Class.

C3384 Mercedes Benz G Class engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)

C3384 Mercedes Benz G Class DTC Meaning

C Chassis Code - Problem is controller area network wiring bus and modules.
3 SAE - Generic
3 IC Module 4X Ref Circuit Intermittent, No Pulses
8 Crankshaft Position Sensor Circuit Performance
4 Cruise Vehicle Speed/Set Speed Difference Too High

While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C3384 Mercedes Benz G Class code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.

C3383 DTC (Previous DTC Code) ( Next DTC Code ) C3385 DTC
You can also check other Mercedes car models :
The listed Mercedes models will give information about C3384 DTC.