C3394 DTC For Mercedes E 280
Mercedes E 280 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | W-Type Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Mercedes E 280 engine control system detects a problem, the computer stores the diagnostic trouble
code C3394 in its memory.
To figure out what is wrong with your vehicle you must first extract the C3394 DTC For Mercedes E 280.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check C3394 Mercedes E 280 that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
C3394 Mercedes E 280 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 3 |
SAE - Generic |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 9 |
TP Sensor Learn Not Complete |
| 4 |
Cruise Vehicle Speed/Set Speed Difference Too High |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C3394 Mercedes E 280 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Mercedes car models :
|
The listed Mercedes models will give information about C3394 DTC.
|
