C3553 DTC For Toyota Prius 3
Toyota Prius 3 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | V-Type Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Toyota Prius 3 engine control system detects a problem, the computer stores the diagnostic trouble
code C3553 in its memory.
To figure out what is wrong with your vehicle you must first extract the C3553 DTC For Toyota Prius 3.
To solve C3553 Toyota Prius 3 problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
C3553 Toyota Prius 3 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 3 |
SAE - Generic |
| 5 |
Auxiliary Emission Controls |
| 5 |
BBV Sensor Circuit Low Voltage |
| 3 |
TFP Valve Position Switch-Drive Without Drive Ratio |
The rule of C3553 Toyota Prius 3 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of C3553. Likewise, overriding the OBD C3553 DTC For Toyota Prius 3 system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
You can also check other Toyota car models :
|
The listed Toyota models will give information about C3553 DTC.
|
